Talley Weatherby Mark V Scope Mount 6 Lug Non-Magnum 1" Medium Black Anodized

Talley Weatherby Mark V Scope Mount 6 Lug Non-Magnum 1" Medium Black Anodized

Traditional two-piece scope mounting systems introduce a ring-to-base interface that can shift under recoil, go out of alignment, or loosen over time. The Talley Weatherby Mark V Scope Mount eliminates that interface entirely rings and base are machined as a single unit from aircraft-grade aluminum, producing a platform that holds zero more reliably than steel two-piece systems at a lower overall weight. Fully CNC machined to tight tolerances, it requires no lapping and installs directly out of the box. Designed exclusively for the Weatherby Mark V Non-Magnum 6-lug action, this Talley Weatherby Mark V Scope Mount 6 Lug Non-Magnum 1" Medium Black Anodized provides additional clearance over the low profile version, accommodating objective lenses that would otherwise contact the barrel or action. Each set includes mounting screws and a T-15 wrench and is sold in pairs. Made in the USA by Talley Manufacturing.

Key Features

One-Piece Integrated Ring and Base : Eliminates the ring-to-base interface found in traditional two-piece designs, removing the most common source of shift and misalignment under repeated recoil cycles without increasing overall system weight.
Aircraft-Grade Aluminum Construction : Provides greater strength-to-weight ratio than steel two-piece alternatives, keeping added system weight minimal while maintaining the rigidity required for consistent zero retention.
Full CNC Machining to Tight Tolerances : No lapping required the mount installs and holds the scope tube in correct alignment straight from the box, saving setup time at the bench.
Medium Ring Profile : Provides additional objective lens clearance over the low configuration, accommodating scopes with larger objective bells while maintaining a secure, stable platform on the Mark V 6-lug action.
Includes Hardware : Ships with 6-48 mounting screws and a T-15 wrench no additional tooling required for installation.

All Technical Data

Brand : Talley
SKU : ISS1243
Compatible Platform : Weatherby Mark V Non-Magnum (6 Lug)
Design : One-Piece Integrated Ring and Base
Material : Aircraft-Grade Aluminum
Finish : Black Anodized
Tube Diameter : 1 in
Ring Height : Medium
Front Hole Spacing : .860" (21.84 mm)
Rear Hole Spacing : .600" (15.24 mm)
Lapping Required : No
Included Hardware : 6-48 Screws, T-15 Wrench
Sold : In Pairs
Origin : Made in the USA

Why Choose This Product?

The medium profile Talley Weatherby Mark V Scope Mount covers the gap between a low mount and a full high the right choice when the objective lens on a standard hunting scope needs more clearance than the low profile allows, without raising the scope higher than necessary for a consistent cheek weld. The same one-piece construction and no-lap installation apply, making it a direct substitute for the low profile version when the objective size requires it.